Installation Guide:
Installation of Mosom Plus Car Cover is a simple procedure. The installation is all about draping the Mosom Plus Car Cover over the vehicle but before moving ahead, it is essential for you to ensure that the vehicle is neat and tidy. For successful Mosom Plus Car Cover installation the procedure is as under:
First of all, ensure that the vehicle is clean and dust free. If the vehicle is not clean, before draping the Mosom Plus Car Cover, then dust particles might get stuck to the car cover and are likely to damage the fabric finish.
Secondly, never drape the Mosom Plus Car Cover over a wet vehicle at any cost.
While installing the Mosom Plus Car Cover, ensure that the Cover does not come in touch with the sharp edged or too hot exhaust tips or else it will get damaged or melt altogether.
If the vehicle is equipped with a fixed –position antenna, you need to create an opening in the Mosom Plus Car Cover to cover the antenna patches. For proper installation of the Mosom Plus Car Cover, remove the antenna first and position the car cover over the vehicle. Then, figure out the base of the antenna and create a small opening in the Mosom Plus Car Cover at the exact position where the antenna meets the base. Then, install the antenna. In the end, you can effortlessly drape the Mosom Plus Car Cover over the antenna.
Mosom Plus Car Cover Installation Process:
To install the Mosom Plus Car Cover, first of all, place it over the vehicle body and unroll it gradually. Then cover the mirror pockets, if fitted to the cover, before moving on to cover the front and rear ends of the vehicle. After successfully installing the mirror pockets, you can easily cover the front and rear bumpers of your vehicle.
Mosom Plus Car Cover Lock Kit Installation:
Mosom Plus Car Cover lock kit has a vinyl-coated cable and is equipped with a metal piece on one end and a loop at the other end. After moving to the passenger’s side, fix the cable loop at a position of around two inches through the grommet. Next, take the metal piece end along under the grommet through the loop of the first cable and take it to the driver’s side. Then from the driver’s corner, pull the cable from outside the cover by two inches through the grommet and lock the end piece to the cable body.